Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> West
> Used
> Crown gear - speed decreaser gear assembly
Crown gear - speed decreaser gear assembly
Crown Gear - Speed Decreaser Gear Assembly
each shaft is 1" diameter x 3".
Each shaft has a key slot that is 1/4" wide x 2 1/4" long x 1/8" deep.
The shafts appear to be stainless steel.
The housing appears to be aluminum.
Though some of the paint has come off.
There is not a name plate on the unit that states the gear ratio.
It appears to be for every 2 turns that the input shaft makes, the output shaft's make 1 turn.
The width of the housing between the 2 output shafts is 6 1/2".
The housing from the input shaft to the back of the unit is 8 1/8".
The height of the housing in approximately 4".
The shafts can go either clockwise or counter clockwise.
