Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> South
> Used
> One 250MHZ oscilloscope clip probes 100X up to 1.2KV
One 250MHZ oscilloscope clip probes 100X up to 1.2KV
One 250MHZ Oscilloscope probes for Tektronix and HP Oscilloscope scope, X100 up to 1.2KV, 2 units + accessories
The Tx3100 series is a passive high impedance oscilloscope probe designed and calibrated for use on instruments having an input impedance of 1M Ohm shunted by 15 pF. However, it may be compensated for use with instruments have an input capacitance of 10-50pF. And within the box cover located near the BNC have one adjust component for the low frequency Trimmer adjustment
Low Frequency Compensation Adjustment:
* Low frequency response can be matched to the oscilloscope by adjusting the compensation trimmer on the head of the probe.
* Connect the probe to the oscilloscope and to a 1Khz square waveform source
* Set the oscilloscope to display two to the three cycles and two to six vertical divisions.
* Carefully adjust the trimmer tool to obtain the flattest tops to the square waves displayed on this oscilloscope,
* High Frequency compensation adjustment
Safety: Conformed IEC-610 10 CATII
1) One 250MHZ Oscilloscope probes with Mini Alligator Clip and ground lead;
