Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> South
> Used
> New cutler-hammer jockey pump controller fdjp-0.75D
New cutler-hammer jockey pump controller fdjp-0.75D
Eaton Cutler Hammer Jockey Pump Controller
* Controller Circuit Volts: 120
* Printed on the case (see picture): Suitable for use as service entrance equipment
* Printed on the case (see picture): Accepted for use, City of New York, Department of Buildings, MEA-18-020-E
ACROSS-THE-LINE JOCKEY PUMP CONTROLLERS
The FDJP jockey pump controllers operate across-the-line, where full voltage is applied
to the motor for starting by the use of a single motor starter. Starting inrush current is
approximately 600% of rated full load amperes.
Built to NEMA Industrial Standards
Dual Set Point Pressure Switch - Rated 15-260 PSI
Magnetic Motor Starter with Adjustable Overload Block
NEMA 2 Enclosure complete with Safety Door Interlock
Hand-Off-Auto Selector Switch
One N.O. Auxilliary Contact - Standard on Controllers up to 7.5HP at 480V.
Oven Baked Powder Paint Finish
120 volt Control Power Transformer
Unit is in NEW UNUSED condition. No damage to the unit at all - pristine condition!
