Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> North
> New
> New amprobe acd-10 plus digtial clamp on meter
New amprobe acd-10 plus digtial clamp on meter
Amprobe s ACD-10 PLUS meter offers thinner jaws over standard clamp meters. Allowing access to tight measurement areas and still accommodating conductors up to 25 mm. It also measures Capacitance and Frequency. Frequency is measured by either jaws or test leads. Very versatile clamp multimeter.
* Thin Jaws, only 10mm (0.4 ) thick
* Hold & Maximum reading functions
* Accommodates conductors up to 26mm (1.02 ) in diameter
* Included Accessories:Test leads, battery installed, soft carrying pouch, and users manual
Size: 190 x 63 x 32 mm (7.4 x 2.5 x 1.3 in)
Safety: Meets EN61010-2-032, UL61010B-2-032, IEC61010-1 2nd Ed., EN61010-1 2nd Ed., UL61010-1 2nd Ed. CAT III-600 Volts ac & dc; Pollution degree : 2
Display: 3-3/4 digits 4000 counts LCD display
Update Rate: 3 per second nominal
Operating Temperature: C to 40 C; < 80% RH for temperature up to 31 C decreasing linearly to 50% RH at 40 C
Altitude: Operating below 2000m; Indoor use
Storage Temperature: -20 C to 60 C, < 80% RH (with battery removed)
Temperature Coefficient: nominal 0.15 x (specified accuracy)/ C @(0 C ~ 18 C or 28 C ~ 40 C)
Low Battery: Below approx. 2.4V
Power Supply: 3V coin battery IEC-CR2032
Power Consumption: 2.8 mA typical except that 3.3 mA typical for ACA function
APO Timing: Idle for 30 minutes
Jaw opening & Conductor diameter: max 26 mm
Special Features: 30ms Max Hold; Data Hold; Relative Zero mode
