Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> Hilti transpointer px 10-273123
Hilti transpointer px 10-273123
Hilti TRANSPOINTER PX 10 273123
INCLUDES PX 10 T TRANSMITTER, PX 10 R RECEIVER, 2 PDA 60 HAND STRAPS, ADHESIVE STRIPS & PUTTY
.A solution to determine start and exit points for your drilling/coring applications. The easy-to-read display shows wall thickness for selection of the proper bit.
Eliminate time consuming procedures such as drilling pilot holes, manual measuring and "trial and error" measuring
Reduce inconvenient overhead drilling by locating points through a floor or wall allowing holes to be drilled from any side
Single person operation with use of adhesive putty
Ability to measure wall and ceiling thickness on most materials (i.e. wood, drywall, block, concrete with or without rebar)
Large display window for measurements
Use of the slope adapter allows angle drilling and coring
Rubber casing protects against dust and is water resistant (IP 56 protection level)
- Locates points through a floor or wall allowing holes to be drilled from either side
- Ability to measure wall and ceiling thickness on most materials (i.e. wood, drywall, block, concrete with or without rebar) for easy selection of the proper drill bit or core bit for the application
PX 10T: Display starts blinking, 2h remaining operation time, PX 10R: Frame of the display starts blinking, 2h remaining operation time
Accuracy may be significantly reduced by irregular positioned reinforcing bars, welded reinforcing mesh, sheet metal or other metal objects close to the tool. Please refer to the operating instructions for details
Accuracy wall thickness measurement (of wall thickness)
Through-hole: average conditions .32" for every 7.87" thickness up to 3.28'. Ideal conditions +/- .08" for every 7.87" thickness up to 3.28' (w/o metal). Wall thickness:
average conditions +/- 5 of thickness up to 3.28'
