Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> Diy spray foam insulation - touch n seal - 600 board ft
Diy spray foam insulation - touch n seal - 600 board ft
* Manufacturer: Touch N' Seal
* Weight: Approx. 108 pounds
* Yield: Approx. 600 board feet (50 cubic feet)
* Density: 1.75 +/- 0.2 per cubic feet
* Other: Use all contents within 30 days of initial dispensing
Spec Sheet: http:// /assets/pdf/two_comp_Foam_Specs.pdf
Data Sheet: http:// /assets/pdf/TNS2KNON-FRTDSrevised7-6-9.pdf
When the Touch 'N Seal Foam mix is sprayed onto your walls, floors and ceilings, the shell of your home becomes protected. It's this protection that blocks heat gain in the summer and heat loss in the winter, thus preventing dramatic temperatures changes in the home. Insulation delivers comfort and lower energy bills during the hottest and coldest times of the year. You can save up to 20% on your heating and cooling as insulation works best when air is not moving through or around it
* 2-Component Foam in Cartons A & B
* Instructions (English, Spanish, French)
* Make sure area to receive foam is clean and dry.
* Ensure your workspace gets adequate ventilation and/or that you wear respiratory gear.
* Make sure ambient and application temperatures are per the instructions.
* Rock the box or tanks to agitate the product thoroughly.
* For best results, ensure foam is between 70 F and 90 F before dispensing.
* Tear open the top of box along perforated lines, and remove instructions and accessories bag.
* Make sure gun is OFF by pushing trigger lock into gun body.
* Attach hoses by connecting the red hose to the red cylinder, and the white hose to the white tank.
* Insert hoses into carton holes, and tighten hoses with wrench provided.
* Close cartons, unlock gun and spray into waste container to ensure chemicals distribute evenly and equally from both hoses.
* Align slots on nozzle with notch on gun barrel and push/twist nozzle clockwise to lock in place.
* Spray again into waste container to ensure product is mixing properly.
