Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Mechanical Control Parts
> 100 pcs. pericom# PI74FCT162501TVC, fast cmos 18-bit re
100 pcs. pericom# PI74FCT162501TVC, fast cmos 18-bit re
This item includes the following: 100 pcs. PERICOM# PI74FCT162501TVC. (SM package). Parts are New/unused and ready for use. As always, we will are willing to look at all Best offers! Please note that we will also consider offers on smaller quantities than we have posted!
PI74FCT16501T, PI74FCT162501T, and PI74FCT162H501T
low power devices with high current drive.
56-pin 240 mil wide plastic TSSOP (A)
56-pin 300 mil wide plastic SSOP (V)
Power off disable outputs permit live insertion
OLP (Output Ground Bounce) < 1.0V
Balanced output drivers: 24 mA
Reduced system switching noise
OLP (Output Ground Bounce) < 0.6V
Bus Hold retains last active bus state during 3-state
Eliminates the need for external pull-up resistors
Pericom Semiconductor s PI74FCT series of logic circuits are produced
in the Company s advanced 0.6 micron CMOS technology,
achieving industry leading speed grades.
The PI74FCT16501T, PI74FCT162501T, and PI74FCT162H501T
are 18-bit are registered bus transceivers designed with D-type
latches and flip-flops to allow data flow in transparent, latched, and
clocked modes. The Output Enable (OEAB and OEBA, Latch
Enable (LEAB and LEBA) and Clock (CLKAB and CLKBA)
inputs control the data flow in each direction. When LEAB is
HIGH, the device operates in transparent mode for A-to-B data
flow. When LEAB is LOW, the A data is latched if CLKAB is held
at a HIGH or LOW logic level. The A bus data is stored in the latch/
flip-flop on the LOW-to-HIGH transition of CLKAB, if LEAB is LOW.
OEAB performs the output enable function on the B port. Data flow
from B port to A port is similar using OEBA, LEBA and CLKBA.
These high-speed, low power devices offer a flow-through
organization for ease of board layout.
The PI74FCT16501T output buffers are designed with a Power-Off
disable allowing "live insertion" of boards when used as backplane
The PI74FCT162501T has 24 mA balanced output drivers. It is
designed with current limiting resistors at its outputs to control the
output edge rate resulting in lower ground bounce and undershoot.
This eliminates the need for external terminating resistors for most
The PI74FCT162H501T has Bus Hold which retains the input s
last state whenever the input goes to high-impedance preventing
floating inputs and eliminating the need for pull-up/down resistors.
