Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Electrical Parts
> East
> Vintage briggs flo-jet carburetor, rebuilt and test ran
Vintage briggs flo-jet carburetor, rebuilt and test ran
This is a small "one piece Flo-Jet" carburetor that fits many of the vintage Briggs & Stratton Models starting in the late 1950s. It was found on the cast iron models 6 and 9 at first and then became the carb used when the aluminum models were introduced. At that point it was used on a lot of Briggs engines, most notably Models 6B, 8B, the 60000 and 80000 series and all their float carb equipped versions which carried a 3 or 4 as the third number in the model designation. An example would be 80>3<101. Ask a Q if you need to know application.
This carb has been soaked in carburetor cleaner and assembled with new gaskets, and new or good used internal parts as needed.
The first pic shows the throttle at idle position so you can judge if it has the lever you need on it. This is the "right" version. You can swap your throttle shaft but you need a 5/32" pin punch. I can also install a "left" version for you if you let me know.