Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Gas Powered
> South
> New
> 55 gal contractors grade concrete sealer x-1 mrsp $899
55 gal contractors grade concrete sealer x-1 mrsp $899
55 gallon drum of Concrete Sealer X-1 manufactured and distributed by Stone Technologies, Corp.
Concrete Sealer X-1 is a permanent silicate based deep penetrating sealer which means that it is guaranteed to last for the life of your concrete because it chemically bonds to the concrete to become part of its integral structure. It is highly effective in making concrete physically stronger and denser protecting it against frost and salt while increasing its resistance to stains, acids, alkalis, moisture, mold and mildew. This product will cure damp and wet basements by preventing hydrostatic water from penetrating through the concrete. It will also stop dusting, efflorescence, spalling, pitting, crumbling and prevent mold, mildew and algae growth. The product will seal the concrete to significantly reduce the level of radon gas penetration which is known to cause lung cancer by the EPA.
Concrete Sealer X-1 can be used in all commercial and residential applications to treat damp or wet basements, concrete floors, walls, driveways, garages, warehouses, storage tanks, pipes, blocks, grout, mortar and stucco. It can also be used to extend the life of exterior wood including fences, patios, decks, cedar and wood shingles.
Concrete Sealer X-1 is easy to apply using a brush, medium nap roller or low pressure sprayer. The surface to be treated does not need any special treatment but it must be oil and dust free to allow proper penetration of the product. It will cover approximately 200 to 400 square feet per gallon depending on the concrete porosity and two coats are recommended. Typically a 5 gallon pail will seal upto 1,000 square feet of poured concrete and two applications are required.
Concrete Sealer X-1 penetrates through the capillaries of the concrete to a depth of up to 4" where it chemically neutralizes damaging chemicals to form a hard insoluble structure based on calcium silicate and calcium hydroxide. Unlike surface coatings this product will not be damaged by efflorescence or be worn down by heavy traffic because it is permanent.
Concrete Sealer X-1 leaves a natural finish (no sheen) after application and the surface will not be slippery. This sealer is not a repellant coating so the concrete can be painted after it has been sealed with increased paint adhesion because the sealer neutralizes the alkalis in the concrete preventing saponification of the paint. Adhesives and epoxy coatings can also be applied over the sealed concrete with no adverse effects.
Concrete Sealer X-1 is environmentally friendly, non-toxic and nonflammable because it does not contain chemical solvents or release any VOC or noxious fumes.
Please contact technical support at ****@stonetechnologiesinc.com if you have any questions
