Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Gas Powered
> East
> Used
> #VH3 sharp combination vertical & horizontal mill '87
#VH3 sharp combination vertical & horizontal mill '87
Preowned SHARP Combination Turret-Type Vertical Mill And Independent Horizontal Spindle, Model: VH3 S/N 450B10047 (New 1987)
(12) Feeds: longitudinal and cross
Rapid traverse: longitudinal and cross
vertical, knee
Spindle speeds, steplessly variable in two ranges
Maximum/Minimum distance, spindle nose to table
Maximum/Minimum distance, centerline of
Horizontal rotating angle of overarm
Distance from center of spindle to overarm
SARGON two-axis digital readout for longitudinal and cross travel of table
ALIGN air power drawbar for vertical spindle
Backlash eliminator for increased cutting stability
(2) Arbor supports, (1) arbor, and drawbolt for horizontal spindle
(5) #40 Tool holders and (1) 3/16"-3/4" capacity JACOBS key-type drill chuck for vertical
1/8 H.P. cutting fluid pump motor with flood coolant pan
3 H.P. table feed and rapid traverse motor
5 H.P. 3/60/220-440 volt vertical spindle drive motor
7.5 H.P. 3/60/220-440 volt horizontal spindle drive motor
