Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Electrical
> West
> New
> Southbend gas oven
Southbend gas oven
USED CONVECTION OVEN SLGS 22SC it was bought in 2008 and used only for 1 year , oven its in great condition and runs like new, here are the specs.
- ENERGY STAR qualified (standard depth only)
- Patented, high efficiency, non-clog Jet Stream burners
- 72,000 BTU (NAT or LP) per oven cavity
- Available standard and bakery depths
- Double deck convection oven is 66-1/2 in height
- Patented plug-in, plug-out control panel - easy to service
- Stainless Steel front, top and sides
- Dependent doors with windows
- Coved, fastener-free, porcelain interior
- Heavy duty, cool touch, stainless steel door handle
- Soft Air, two speed, 1/2 hp, fan motor
- 11-position rack guides and 5 plated oven racks
- Electronic ignition with solid state temperature controls
140 F to 500 F solid state thermostat and 60 minute
CCH-Cycle / Cook & Hold Control
150 F to 500 F temperature controller with 140 F to 200 F Hold
thermostat Dual digital display shows time and temperature. A fan
(SLGS/22SC shown with optional casters)
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish: Stainless steel front, top and sides. Aluminized
Doors: Dependent doors with windows. Stainless steel
construction, heavy-duty welded steel frame and 5/8 diameter
Oven Interior: Porcelain enamel finish, coved, fastener free.
Rack and Rack Guides: Heavy-duty removable wire rack guides
spaced on 1-5/8 centers offer 11 different rack positions. 5 wire
racks provided with each oven.
Blower Fan and Motor: 1/2hp, 2-speed motor, 1725/1140
Oven Heating: 72,000 BTU NAT or LP). Oven heating is
regulated by an adjustable solid state thermostat control. Blower
fan circulates air within the cavity scrubbing heat to the oven
interior for even heat distribution within the cavity.
Electronic Ignition: Hot surface ignitor with flame safety
Control Panel: Located of front, at right side of oven, away
from heat zone. Removable panel opens downward for easy
Legs: 6 stainless steel legs standard.
Note: Oven cannot be operated without fan in operation.
From SLG/22 Rev 5 (November/2009)
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526(***) 762-1000 Models:
.SLGS/22SC .SLGS/22CCH .SLGB/22SC .SLGB/22CCH
If using flex hose connector, the I.D should not be smaller than
3/4 and must comply with ANSI Z 21.69.
If casters are used with flex hose, a restraining device should
be used to eliminate undue strain on the flex hose.
Clearances from combustibles: Top-0 , bottom-0 , right side-0
Recommend - install under vented hood
Check local codes for fire and sanitary regulations
If the unit is connected directly to the outside flue, an A.G.A
approved down draft diverter must be installed at the flue outlet
Oven cannot be operated without fan in operation
Notice: Southbend reserves the right to change specifications
and product design without notice. Such revisions do not entitle
replacements for previously purchased equipment.
GAS: Standard and Bakery Depth: 72,000 BTU (NAT or LP) per
Required minimum inlet pressure:
ELECTRIC: Standard: 120/60/1 phase, furnished with 6 cord w/3-
prong plug (1 plug/deck). NEMA #5-15p. Total maximum amps 7.9.
Optional: 208/60/1 or 3* phase (190-219 volts). Supply must be wired
to junction box with terminal block located at rear. Total maximum amps
4.3 per deck. Optional: 240/60/1 or 3* phase (220-240 volts). Supply
must be wired to junction box with terminal block located at rear. Total
maximum amps 3.8 per deck. Optional: 240/50/1 or 3* phase (208-240
volts). Supply must be wired to junction box with terminal block located
at rear. Total maximum amps 6.0 per deck
. Stainless Steel oven interior
. Stainless Steel exterior bottom
. 208/240V 50/60 cycle ( for use on 1 or 3
. Swivel Caster - front with locks
. Down draft diverter for direct flue
. 3/4 quick disconnect with flexible hose
(specify length: 3ft, 4ft, or 5ft)
. 2 air insulation panel ( stainless steel
