Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Electrical
> East
> New
> Gmp J2 lasher (used 5 times)
Gmp J2 lasher (used 5 times)
GMP J2 LASHER IN ALMOST NEW CONDITION USED 4-5 TIMES (LESS THAN 2500')
* Will lash any single or multiple aerial cables up to 3 in. (76 mm) diameter across on any suspension strand from 1/4 in. (6 mm) to .535 in. (14 mm). A factory modification will allow the lasher to accommodate 1/2 in. (12.7 mm) strand if necessary. (P/N 86072)
* Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable lifters, cable and strand rollers
* Each of two recessed magazines will hold a 1200 ft. coil of .045 in. (365 m of 1.1 mm wire) lashing wire (or 450 ft. of .065 in.). The Lashing Wire is fully recessed and covered by a gate.
* Features a fast setup procedure, quick coil loading, and automatic drum lock for easy span transfers and smooth forward travel
* J2 Cable Lashers make overlashing easy. Just push down on the strand roller knob, rotate it a quarter turn and you can lash additional cables together on previously lashed cable
* Constructed with heat-treated, plated steel, stainless steel, brass and aluminum components. Contains sealed and oiless bearings to minimize maintenance and assure durability. Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break
* Pre-drilled and tapped at the factory for mounting of the lasher guard or "halo". For use when lashing in overgrown areas.
* The lasher is furnished with a rugged lightweight storage chest with corrosion resistant hardware, recessed latches and a moisture-proof, tongue-in-groove design for maximum protection when not in use
* Supplied with a 6 ft. bridle rope assembly and snap hooks, and an information and operation manual
