Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Diesel Powered
> South
> Used
> Two bullet resistant bank teller windows + 9.5 ft.
Two bullet resistant bank teller windows + 9.5 ft.
Another Trader Assistant Consignment
TWO BULLET RESISTANT GLASS (Polycarbonate) TELLER WINDOWS
Not all that easy to take images of, especially un-installed. I tried looking for similar on line with images of it installed but could not locate any. There are the solid pieces with the small talking hole and those with arched tops but none with the blow out voice port window that this has and the straight tops. Could very well be that your bank has some like this and you can visualize it installed.
The total length all installed is around 115 inches(9.5 ft.) by 52 inches high. See rough sketch below of how this looks mounted and all measurements. (The 80# is the weight of the section). There are two window sections measuring around 26 inches wide by 52 1/2 inches high and all material is 1 3/8 inch thick. Two side pieces approx. 36 inches wide by 38 in high. These would cover the area between each window and to one side on top of a short counter wall. The other side would have to be a wall. It is suggested as most banks and convenience stores use that you have bullet resistant fiberglass sheet under the counter and behind any side walls. Or heavy sheet metal just in the event a bad guy shoots in those areas. I believe the rating on this is UL-752 or # 3. Fact being that these came from a bank and from what I ve read on line most all material used by banks is #3 that will resist bullets from 38 cal., 9 mm or .357. These are the caliber that most robbers use since the guns are easily hidden in pants or bag upon entering the building. The rating can be determined by a formula that takes total sq. inches, thickness and weight to calculate. This is available on a few sites.
This listing also includes two, 2 inch high 8 in. deep by 20 inch long stainless money trays, aluminum C molding, screws, spacers, bolts and nuts.
This all came out of a closed bank last October and was only purchased and installed two years prior to that. The condition is excellent but there are still some small scratches on it and some chips on the edge and corners that get covered by the aluminum C bar molding.
I m told that the cost for this on average is around $2.00 per sq inch so being approx. 5400 sq inches this cost $11,000 new. We purchased about 45 ft (5 windows) and this is what was left over and not needed.
This is available for inspection prior to purchase. We will deliver at no charge up to 50 miles from West Palm Beach. Or a days ride (12 hrs. round trip) for $400. Other wise you need to pick it up at our location. We will not get involved in crating and freight on this. The total weight of the four pieces is around 350 pounds
FLORIDA & LOCAL DELIVERY OR PICK UP AT LOCATION ONLY
Unless an item is stated as being new, there could be slight wear consistent with age.
Florida residents are required to pay sales tax of 6.5% or we will accept faxed copies of your signed resale certificate.
Unique & Precious, Inc. entire liability to you and any third parties under any circumstance is limited to the selling price of the relevant goods and $100.
