Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Diesel Powered
> East
> Used
> New us cooler 8'X8' i/d walk-in cooler, top mount ref.-
New us cooler 8'X8' i/d walk-in cooler, top mount ref.-
US Cooler 8'x8' I/D Walk-in Cooler, Top Mount Ref.-NEW
3/4 HP Top Mount Indoor Refrigeration
* This walk-in comes with a 3/4 HP top mount indoor refrigeration system. System comes with a condensing unit, evaporator unit, and associated parts installed on a walk in cooler plug. This unit is pre-charged and ready to be set in the top mount refrigeration hole on top of the walk in. It does require the installation of the evaporator condensate line, which needs to be run to a drain. This refrigeration system rates a 2 on a scale of 5 with 5 being the hardest most technical to install and 1 being the easiest. This refrigeration system must be installed by a licensed refrigeration technician. Our company can assist you with this requirement.
* This indoor walk-in requires a minimum of 5,442 BTUs
REFRIGERATION - Top mounted refrigeration system, self contained, med temp, 1 phase, 3/4 HP, hermetic, 208-230 volt. Includes: Copeland condensing unit, evaporator, thermostatic expansion valve, high pressure control, sight glass, drier, solenoid valve, thermostat. maximum low 35 degrees. refrigerant - R22. Unit mounts on a 22 1/2" x 33" plug.(Refrigeration is based on an altitude of 5000 feet or less)
* FLOOR - Floor panels consist of extruded high density polystyrene foam insulation sandwiched between stucco embossed 26 gauge galvalume outside and 22 gauge stainless steel inside.
