Machine Recycling Discussion and Moderated Newsgroup > Parts Machines
> Diesel Powered
> East
> New
> Century® wire feed 180 by lincoln® 220 volt mig welder
Century® wire feed 180 by lincoln® 220 volt mig welder
ALL EQUIPMENT SOLD IS NEW AND IN ORGINAL FACTORY PACKAGING:
Century Wire Feed 180 by Lincoln
A rugged performer. The Wire Feed 180 is designed for either gasless flux-cored welding, or MIG welding with optional 314RH regulator kit plus correct shielding gas. This unit runs off industrial 220V input power for maximum performance. Light fabrication, autobody welding and farm repairs are just some of the jobs the Wire Feed 180 can handle with ease.
Welds 20 gauge up to 1/2" inch steel with flux cored wire
Cold electrode until gun trigger is pressed for an added measure of safety.
Overload protection incorporates both a thermostat and a circuit breaker.
Quality wire drive with electronic overload protection.
Quick Release idle roll pressure arm is easily adjusted.
Reversible, dual groove drive roll.
Accommodates both 4 (100 mm) diameter and 8 (200mm) diameter spools of wire (with optional KH720 adaptor).
10 ft (3 m) work cable with clamp
1 lb spool of .035 in (0.9 mm) self shielding flux cored wire.
10 ft (3 m) Power cord with plug.
Rated Output at 25% Duty Cycle - 130 A at 20VDC/208V
Rated Output at 30% Duty Cycle - 130 A at 20VDC/230V
Input voltage: 208/230V/1Ph/60Hz
Dimensions: 12" x 9.75" x 16.5"
Warranty: Three year parts and labor (90 days on gun and cable)
