Machine Recycling Discussion and Moderated Newsgroup > Full Machines
> Incomplete Machines
> Cutler hammer nema size 5 no. A10GN0 motor starter 3PH
Cutler hammer nema size 5 no. A10GN0 motor starter 3PH
THIS SALE IS FOR 1 CUTLER HAMMER No. A10GN0 SERIES A1
NEMA SIZE 5 3 PHASE STARTER ASSEMBLY.
LABEL INDICATES USES CONTACT KIT 6-27-2
LABEL INDICATES 120V 60 CYCLE, 110V 50CYCLE 1891-1.
THE SIDE SHOWS - AUX CONTACT SERIES NUMBERS
C320KB8 SERIES A2 AND C320KA3 SERIES A2 ARE PRESENT.
THE CURRENT TRANSFORMER IS P/N 42-2807 WITH RATIO 300/5.
THIS UNIT WAS PURCHASED AS SURPLUS AND I AM UNSURE OF THE CONDITION AND DO NOT HAVE SUFFICIENT KNOWLEDGE TO EVALUATE IT. IT MAY HAVE BEEN REMOVED FROM SERVICE AS EQUIPMENT CHANGEOVER AND WAS WORKING FINE, OR IT MAY HAVE BEEN REMOVED FOR AN OPERATIONAL DEFECT. THE PHYSICAL CONDITION LOOKS FINE, HOWEVER PHYSICAL CONDITION LOOKING FINE HAS MINIMAL MEANING.
THE WIRE HOOK UP TERMINAL T3 MAY SEEM PRESENT IN SOME OF THE PICTURES AND WAS PRESENT ON THE PRIOR UNITS SOLD HOWEVER IS NOT PRESENT ON THIS REMAINING UNIT. I DIDN'T TAKE ALL NEW PICTURES OF THIS UNIT BUT ADDED PICTURES THAT SHOW THE T3 WIRE CONNECT TERMINAL MISSING. THE TWO HEX HEAD SCREWS THAT HOLD THE TERMINAL ON ARE ALSO MISSING. NOT SURE IF WHEN TAKEN OUT OF SERVICE WHETHER ALLEN HEAD SCREW WAS STRIPPED OR WOULD NOT LOOSEN, SO THERE WAS NO WAY TO DISCONNECT THE WIRE WITHOUT REMOVING THE TERMINAL; OR POSSIBLY ONLY 2 POLES WERE NEEDED IN THE PRIOR APPLICATION SO THERE WAS NO NEED TO HAVE A WIRE CONNECTION TERMINAL ON THE T3 LINE. NOT SURE OF THE REASON, BUT IT IS NOT PRESENT. THE L1, L2, AND L3 LUGS ARE PRESENT.
