Machine Recycling Discussion and Moderated Newsgroup > Full Machines
> Complete Machines
> Welders
> East
> New
> 1-15/16" extra length end mill cutter 11"+ long flute
1-15/16" extra length end mill cutter 11"+ long flute
This extra length cut end mill is in Good sharp used condition. It does have a chamferred leading edge instead of sharp point 90 degree corners
Cutting diameter is approx. 1.946"
It has approx. 11-3/4" of Flute Length
It has 6 Flutes and it is not center cutting. This cutter has the 2 flat spots on the shank for the set screws and it also has the grooved slot for Eclipse twist lock quick change tool holders.
US Made but I can not read the name USA
This is not an actual photo but it is pretty much identical to the one in the photo but this one is not center cutting. I have had a few of them in the past that were pretty much all the same so I have used this same photo for each one.
