Machine Recycling Discussion and Moderated Newsgroup > Full Machines
> Complete Machines
> Metalworking
> 10W tuner module for icom 706 718 746 756 pro
10W tuner module for icom 706 718 746 756 pro
I bought a Ten-a-Tuner by Bob W2ENY that I didn't need. Still in Package
Activate the 'tune' feature in your Icom
This new unit works with Icom's having an antenna tuner connector on the rear of the radio (like for the AH-3 or AH-4 external). Simply plug this device into the jack and your radio will think there's an Icom antenna tuner attached. This activates the 'tune' button on the front panel of the 706 series (and others 718, 746, 756, 7000, etc.). When the tune button is pressed, the radio will transmit a low power 10 watt CW signal for approximately 8 seconds*. This low power signal minimizes risk and damage to your finals while you check match, swr or tune the antenna with your own external tuner. This is most useful for tuning your amplifier and high power tuner at much lower power levels.
FYI, In someones infinite wisdom at Icom, they have disabled the internal SWR and RFout display in the 7000, you will need an external wattmeter.
The adapter/interface is small and compact. This is a first class product, using a properly fit thick high quality vinyl boot (no cheap heat shrink tubing). High temperature adhesive is used to pot the components, sealing out moisture and retaining the boot. This boot does not slip off. There is no PC board, or klunky box hanging off the back of your radio. This is ideal for mobile and portable use as it's about the same size as the connector itself. The passive network used here is a long lasting streamline solution for your application.
Complete with installation and application note.
Over 4000 sold with ZERO problem, fully guaranteed and supported!
Your ICOM radio has a low power TUNE feature, Activate it today!
The unit is new. Ordered it and didn't need it as we ordered a Auto-tuner at the same time.
