Machine Recycling Discussion and Moderated Newsgroup > Full Machines
> Complete Machines
> CNC
> East
> Dmi tiger-two 5 shank v ripper w/disc cutters
Dmi tiger-two 5 shank v ripper w/disc cutters
folks if your looking for a serious deep till ripper here it is. i personally have owned this for probably 10 years. i bought it at a neighbors farm sale and used it off and on the years i`ve had it. we have not used it for 2 years and i really don`t use it enough to justify keeping it. in the time i`ve owned it we put on a new 16.5x16.1 tire on it. both the main beams have been slightly bowed due to turning to short but no damage is done. i bought it just the way it is with the harrow frame welded on the back. there has been a place or 2 where a stop has been rewelded and i dont know why the bracket is welded on the main pipe unless it had something to do with the harrow. the bushings are tight and good. all cylinders are fine. this is a 5 shank ripper with the spacing on 30 inches. the frt. disc frame is just over 14ft. wide and the discs measure 19 1/4 inches across. the rear shank and assembly is almost 5ft. tall and will go 2 ft. down with no problem. all this needs to go to work is greased. we are located in corning ia. and pickup will be from here. the serial tag says model tiger5 and the # is 801712. thanks. houck supply>ray (***)-358-2931 or my cell is (***)-202-4998 also loading is no problem
