Machine Recycling Discussion and Moderated Newsgroup > Components
> Wheels and Bearings
> East
> Used
> Gas pilot assembly Q179A flame rod & ignitor electrode
Gas pilot assembly Q179A flame rod & ignitor electrode
Gas Pilot Assembly Q179A Flame Rod & Ignitor Electrode
Gas Pilot Assembly Q179A Flame Rod & Ignitor Electrode
Honeywell Gas Pilot Burner Assembly with SGI 250 high-voltage lead wire
* Q179A1118 is a Flame Rectifier Pilot with a 0.025 in. dia. Orifice and 45 degree left hand port and tip style.
* Q179A is a gas pilot assembly with a flame electrode (rod) and ignition electrode,
making it suitable for applications requiring an interrupted or intermittent electrically ignited
* Its ignition electrode is for use with 6,000V grounded secondary-ignition transformer.
* Primary aerated type burner is equipped with stainless steel fins that provide the proper
flame rod area to ground area ratio for maximum flame signal and flame stabilization.
* Stainless steel electrode(s) are mounted in ceramic insulators, which permit electrode
* Rajah connectors facilitate disconnecting.
* SGI 250 high-voltage lead wire is designed for gas igniter systems for furnaces, heating and
air-conditioning units, gas water heaters, range top burners, ovens, piezoelectric spark igniters
and similar applications up to 250 C.
* Standard Conductor: Nickel-plated copper.
* Standard Color: Red only.
Primary aerated. Stainless steel fins provide proper flame contact area to ground area. Flame electrode
and ground bracket are furnished with each tip.
Bracket has holes for side mounting and two lugs for end mounting.
Natural; for LP gas, order LP orifice separately
Approximately two cu ft/hr.
Stainless steel, maximum temperature 1750 F (954 C).
Rajah connector (both male and female supplied).
Underwriters Laboratories Inc. listed, File No. MP268;
Industrial Risk Insurers acceptable;
CSA certified, Master File No. LR-95329-1;
American Gas Association certified, No. G140.401.
