Machine Recycling Discussion and Moderated Newsgroup > Components
> Structural Parts
> South
> Lab frame, med-duty, 1/2" round stainless steel, 4'X4'
Lab frame, med-duty, 1/2" round stainless steel, 4'X4'
MEDIUM-DUTY LAB FRAME, 4 Ft by 4 Ft and 24 Inches Deep. Made of 1/2 inch round ASTM-304 STAINLESS STEEL tubes connected and anchored by our tough Rotocon Zinc-alloy Assembly Clamps using nickel-plated steel nuts and screws. Sturdy construction with support at 12 inch intervals will accomodate medium loads without problems providing a very strong lattice support. There are four anchoring bases which can be attached to your table top, plywood base or floor to prevent tipping over. These clamps can connect at 10 degree intervals and will allow much versatility in design and construction. Detailed suggested assembly instructions for frames as pictured are included. The kit contents are as follows: 12 each 1/2 inch round stainless steel tubes 4 ft. in length, 2 each 1/2 inch round stainless steel tubes 2 ft. in length, 33 sets SRT-1/2 Zinc-alloy Snap-On Assembly Clamps and 2 sets M-90 Zinc-alloy Mounting Base. Assembly required. Tape measure, flat blade screwdriver, slip joint box pliers and 8 wood screws or bolts for anchoring are needed but not included in package.
We have other frames available, if desired. We have other sizes ( 3 feet by 3 feet, 3 by 4 ft, 4 by 4 ft, 4 by 5 ft and 5 by 5 ft in stainless steel rods, white fiberglass rods and even hardwood oak rods, all in our Rotocon store). Please visit at your convenience.
