Machine Recycling Discussion and Moderated Newsgroup > Components
> Complete Control Circuits
> West
> Used
> Rothenberger dies 1/4" nc fits snap o matic uniquad 22A
Rothenberger dies 1/4" nc fits snap o matic uniquad 22A
1/4" UNC (UNITED NATIONAL COURSE) A.K.A. NC
This is the thread used for 1/4 inch "All Thread" rod. (Used for making hangers for pipe, duct work, vents, waterlines and all kinds of other stuff the needs to be suspended or strapped.)
I have included a couple of screen shots from Rothenberber to help you MAKE SURE these are what you want.
According to Rothenberger these fit:
and UniQuad die heads as all use: Die Table #9 (as seen in last photo)
I do my best to provide multiple large, high quality photo(s) and descriptions that will fairly represent the listed item(s). No deception is intended.
Dies have a bit of packing tape sticky stuff on them... could be cleaned w/thinner no problem.
