Machine Recycling Discussion and Moderated Newsgroup > Components
> Complete Control Circuits
> North
> Used
> 2 thk linear lm guide rails 87"+2 bearings shs 45 SHS45
2 thk linear lm guide rails 87"+2 bearings shs 45 SHS45
2 THK Linear LM Guide Rails 87"+2 Bearings SHS 45 SHS45
This a Lot of 2 THK Linear Motion guide rail, approximately 87" long, each with (2) SHS45 bearing blocks. These were pulled from a working machine and are in generally Good/Used cosmetic and working condition. The bearing runs smooth on the rail. There is a short hand-etched block of text on the rail's end and on top of the block. Note also, some have a Zerk-style grease fitting as shown; some do not. NO manuals or additional accessories are included if not shown. Item shown in the photos is a typical unit.
* Bearing Dimensions (excluding grease fittings): 86mm x 174mm
* Total Assembled Height (bearing on rail): 70mm
* Basic Load Ratings (Radial, Reverse Radial, AND and Side*):
* Static Load Rating: 166,000N
* Dynamic Load Rating: 100,000N
* With ball cage for increased service life & low rolling resistance
*Since each row of balls is arranged at a contact angle of 45 , SHS 45 linear motion guides can handle loads from all directions (radial, reverse radial, and horizontal) with its 4-way equal load rating capability.
