Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Knobs and Handles
> West
> Used
> Applikon bio console adi 1030 and 1035
Applikon bio console adi 1030 and 1035
A used Bio Console and Controller 1035 & 1030. The console has been powered up and all pumps cycle and temperature modes work. It was decommissioned from a major pharmaceutical company less than a month ago. The unit can be supplied calibrated at extra cost.
TTS offer a money back guarantee on any equipment being DOA.
The ADI 1030 is a user friendly controller offering accurate control of optimum conditions for cells or micro-organisms. It offers a wide choice of parameters and advanced control strategies. The 1030 has bi-directional interfaces to allow communication with a PC and network operation is possible. The Bio-controller accepts 4 inputs and provides 11 control outputs. These are configured as 9 digital and 2 analogue outputs. All outputs are fully programmable. This controller is configured with these inputs:
* Dissolved oxygen (polarographic)
The Bio Console integrates all the necessary peripheral equipment to run and control a bioprocess.
This Bio Console is configured to accept 3 fixed speed pumps and can also be retrofitted with one variable speed pump. The pump heads which are fitted to these drives are peristaltic tubing pumps. The flow range and gas type can be specified for the application, as required. Each rotameter provides a needle valve for manual adjustment of gas flow. A separate 3-way valve allows the operator to select gas flow to the sparger or gas overlay. A third position allows the gas flow to be shut off. In addition, solenoid valves are available for each rotameter to control gas flow as a function of dissolved oxygen or pH setpoint.
The Bio Console also can incorporate a motor speed controller, foam controller and temperature controller. For temperature control, several options are available. A thermocirculator can be installed which allows water to flow to the heat exchanger or jacket of the bioreactor. As an alternative, a heating blanket or heating element can be plugged into the Bio Console. For cooling purposes, a cold water solenoid valve can be installed. A foam controller is installed in the Bio Console which frees up additional space in the Bio Controller for measurement and/or control of another parameter.
All devices described above are controlled from the ADI 1030 Bio Controller when installed above the Bio Console.
The basic Bio Console includes all the necessary connections for water supply, gas supply and power. Manifolds allow mixing of gases. Water supplies are also brought to a manifold and a separate connection is provided for cold water supply to the air outlet condenser. A central power supply switch controls power to the various modules as well as the Bio Controller. The power section of the Bio Console also includes fusing for protection of the Bio Console and all components. An "alarm" LED is provided which can be used to provide a general alarm status based on sensor input signals.
Tailored Test Solutions Limited.