Machine Recycling Discussion and Moderated Newsgroup > Separate Parts
> Knobs and Handles
> North
> Shot blasting machine ls industries structural 24 x 24
Shot blasting machine ls industries structural 24 x 24
Airless steel shot blasting system with opening size 24 x 24
Main blast cabinet construction: 1/4 manganese
3/8 manganese wear plate liners in direct shot blast pattern
Four (4) LS TurboShot TM impeller wheels. Two overhead wheels. Two lower wheels,
LS TurboShot TM wheel motors: 15 HP each
Each LS TurboShot TM wheel has four blades
LS TurboShot TM impeller wheel lined with replaceable wear plates
Heavy duty 2 spherical four bolt flange bearings on the LS TurboShot TM impellers
Abrasive feed system including augers, collection hopper, bucket elevator and air wash.
Elevator: 10 gauge construction, 5 HP with 6 x 4 buckets. Multiple ply elevator belt
Shot containment vestibules constructed from 10-gauge steel
Vee tray and auger extends from the exit and entrance to return abrasive.
Maintenance door to allow operator access to the interior of the blaster.
Maintenance and inspection panel on augers and elevator
Electrical box located on blast cabinet
Single point electrical connection
Power: 440 volt 3 phase power 60 cycle. Approximately 108-amp draw.
NEMA 12 electrical enclosure
Cutler-Hammer high voltage components; UL registered components
Amp meter to monitor abrasive load on each LS TurboShot TM impeller wheel
Dust collector (ducting not included, quoted on request)
2,000 CFM, 4 replaceable cartridges 1,240 sq ft filter material
10-15 CFM @ 100-125 PSI required to operate dust collector pulse
Blaster opening size: 24 x 24
Lifting hooks integrated into the blast cabinet
Replacement cost Approximately $ 186,000.00
Call me if you have any questions (***)-912-7426 or ****@yahoo.com
