Machine Recycling Discussion and Moderated Newsgroup > Components
> Structural Parts
> West
> New
> Thermoflex heat applied t-shirt vinyl 15" X5YD white
Thermoflex heat applied t-shirt vinyl 15" X5YD white
Thermo-Flex Plus is a heat transfer material suitable for most cotton, cotton-polyester, wool, lycra, and other basic fabrics including many athletic mesh fabrics. The self adhesive layer permits high speed cutting, ultra-fine detail, and easy weeding. Cut in mirror image through adhesive layer (dull side) to the plastic backing. Weed the excess material and lay the cut pattern on the fabric. Cover the design area with paper or cloth release sheet. Irons can be used, but for best results, a heat press is preferred at 340 -350 F for 20 seconds. When transfer is cool to the touch, peel away backing sheet. Transferred image may be covered with a non-stick sheet and re-heated if necessary. you should use firm or hard pressure for proper transfer
Create plotter file in mirror image
Cut mirror image on plotter and weed design
Position weeded design on shirt
Place Teflon sheet or silicone release sheet over design
Hard pressure 345o to 350o F for 20 seconds
Rub design with pad or eraser while still hot
All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance for conditions not under manufacturer s control. Before using, please determine the suitability of product for its intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller s and manufacturer s only obligation shall be to replace such quantity of the product proved to be defective by manufacturer.
